|
Post by sphinx on Apr 12, 2007 15:07:53 GMT 8
how can you test kung yung particular cell sa pack is in good condition or not.
Ok, dismantled ko na yung mga batteries, what kind of test do i need to do and what result should i expect for each individual cell?
dami ko kasing battery, sayang naman kung may mga cell na puede pang gamitin... pagsasamasamahin ko siyempre yung pare-parehong ratings at yung pare-pareho ng test result.
anyone?
|
|
|
Post by SnakeDoctor on Apr 13, 2007 11:49:11 GMT 8
the cells should have the same volt rating in a pack.
1.2 volts per cell and 1.4 volts if fully charged
if they have the same volts then you cant determine w/c is good or bad
|
|
|
Post by sphinx on Apr 13, 2007 22:11:21 GMT 8
ang hirap naman. trial and error na lang siguro ang katapat nito. full charge yung buong pack, then discharge the cells individually. yung pinaka mahabang time mag-discharge, siguro yun ang ok.
|
|
|
Post by SnakeDoctor on Apr 15, 2007 14:21:59 GMT 8
nicd or nimh? try fully draining the cells then charge it for the nicd. for nimh- your the expert on that!
|
|
|
Post by sphinx on Apr 15, 2007 19:53:33 GMT 8
may nimh, meron ding nicad. thanks for the info SnakeDoctor.
|
|
|
Post by deltasniper on Apr 16, 2007 4:39:54 GMT 8
First check them by appearance of each battery...leak, yung nag start na syang mag corrosion .. and then individual test using tester. if the battery are same volt start.. discharging using buld. see kung alin ang mabilis mag discharge.. PATIENCE.. other wise.. bumili ka nalang nang bago..
|
|