Post by SnakeDoctor on Feb 23, 2008 13:04:55 GMT 8
Let me share you folks some of the troubleshooting tips w/ your aeg hop-up
Does your bb's grouping worst than before? or it goes left or right? look no further try out my tips for get your hop-up back to shape.
here's a pic of a m4/m16 type hop-up with all its parts included
Most of the time the problem w/ hop-up's are they are dirty so if you got some bad grouping/bb's banking issue just get your trusty cleaning rod, silicone oil and cotton and clean way
How to clean your barrel/hop-up-
a. dethingy/clear the hop-up chamber
b. set hop-up to zero/off
c. wrap cotton on cleaning rod spray/dab some silicone oil and clean away
IF problem persist then...
a. Disconnect/disassemble hop-up and inner barrel assembly
b. inspect for damage on hop-up rubber. the smallest damage/tear/marks on the hop-up rubber can cause bad groupings or banking shots
c. check the alignment of the hop-up vs the barrel. the barrel will have a notch where you can use as a guide to align both hop-up/barrel
d. finally make sure that the rubber is installed properly and that the hop-up plunger arm is pushing the hop-up rubber downwards
Does your bb's grouping worst than before? or it goes left or right? look no further try out my tips for get your hop-up back to shape.
here's a pic of a m4/m16 type hop-up with all its parts included
Most of the time the problem w/ hop-up's are they are dirty so if you got some bad grouping/bb's banking issue just get your trusty cleaning rod, silicone oil and cotton and clean way
How to clean your barrel/hop-up-
a. dethingy/clear the hop-up chamber
b. set hop-up to zero/off
c. wrap cotton on cleaning rod spray/dab some silicone oil and clean away
IF problem persist then...
a. Disconnect/disassemble hop-up and inner barrel assembly
b. inspect for damage on hop-up rubber. the smallest damage/tear/marks on the hop-up rubber can cause bad groupings or banking shots
c. check the alignment of the hop-up vs the barrel. the barrel will have a notch where you can use as a guide to align both hop-up/barrel
d. finally make sure that the rubber is installed properly and that the hop-up plunger arm is pushing the hop-up rubber downwards